CUSTOMER REQUESTS ALIGNMENT CHECK-CHECK AND REPORT
CUSTOMER STATES REPLACED ALL TIRES DUE TO UNEVEN TIRE WEAR AND OUTSIDE SHOP DID NOT RECOMMEND ALIGNMENT. CUSTOMER REQUESTS ALIGNMENT CHECK
PLACE VEHICLE ON ALIGNMENT RACK, ATTACH EQUIPMENT, MEASURE CASTER, CAMBER AND TOE. COMPARE TO VEHICLE SPECIFICATIONS. SET AND ADJUST ALL APPROVED ALIGNMENT ANGLES WITH ALLOWABLE SPECIFICATIONS.
Credit Card Convenience Fee
GREEN J. gave our service a 5 star review on 4/27/2024
CUSTOMER STATES HOOD LATCH DOES NOT WORK -CHECK AND REPORT
HOOD LATCH RELEASE CABLE – Remove & Replace
VALVE COVER GASKET – Remove & Replace – V6 Left
VALVE COVER GASKET – Remove & Replace – V6 Right Side
RADIATOR HOSE – Remove & Replace – V6 Both
Performed service. Circulated Justice Brothers Cooling System Cleaner with original coolant. Drained engine coolant, added new coolant and circulated conditioner with new coolant
POWER STEERING HOSE – Remove & Replace – V6 Pressure
Performed service. Removed original fluid from power steering system. Added new fluid and conditioner. Inspected for any leaks for system faults. Testdrove after service performed
MOUNT AND BALANCE ONE TIRE/WHEEL ASSEMBLY.
SPARK PLUGS – Remove & Replace – V6
PERFORMED SERVICE-CIRCULATED PART 1 IN FUEL, PART 2 IN ENGINE OIL AND PART 3 INTRODUCED THROUGH VACUUM SOURCE INTO ENGINE'S PCV SYSTEM. DROVE VEHICLE AFTER WORK PERFORMED
CLEAN THE MASTER CYLINDER CAP AREA AND REMOVE THE OLD FLUID FROM THE RESERVOIR. FILL WITH FRESH FLUID AND FLUSH WITH POWER BRAKE FLUSH MACHINE BY PRESSURIZING BRAKE MASTER CYLINDER AND VACUUMING OLD FLUID OUT OF EACH BRAKE BLEEDER UNTIL THE FLUID IS CLEAN
Credit Card Convenience Fee
DONNA H. gave our service a 5 star review on 3/28/2024
SHOCKS AND STRUTS ORIGINAL EQUIPMENT REAR SHOCKS LEAKING FRONT LOWER CONTROL ARM BUSHINGS BAD RECOMMEND FRONT BRAKES, CLEAN AND ADJUST REAR SHOES, BRAKE FLUSH STRUTS WILL NOT HOLD ALIGNMENT WITH TORN BUSHINGS
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
PLACE VEHICLE ON ALIGNMENT RACK, ATTACH EQUIPMENT, MEASURE CASTER, CAMBER AND TOE. COMPARE TO VEHICLE SPECIFICATIONS. SET AND ADJUST ALL APPROVED ALIGNMENT ANGLES WITH ALLOWABLE SPECIFICATIONS.
CONTROL ARM – Remove & Replace – Lower,Both – [DOES NOT include alignment.]
DISC ROTOR – Remove & Replace – Front,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
CLEAN THE MASTER CYLINDER CAP AREA AND REMOVE THE OLD FLUID FROM THE RESERVOIR. FILL WITH FRESH FLUID AND FLUSH WITH POWER BRAKE FLUSH MACHINE BY PRESSURIZING BRAKE MASTER CYLINDER AND VACUUMING OLD FLUID OUT OF EACH BRAKE BLEEDER UNTIL THE FLUID IS CLEAN
CLEAN AND ADJUST REAR BRAKE SHOES
CUSTOMER STATES DRIVER SEATBELT DOES NOT CLICK IN- CHECK AND REPORT
SEAT BELT BUCKLE – Remove & Replace – Each
GAIL B. gave our service a 5 star review on 12/22/2023